Low Platelet Count and Mechanical Valve

Help Support ValveReplacement.org:

T-Money

Well-known member
Joined
Apr 2, 2005
Messages
117
Location
Louisiana
Hi.
I found out today that my platelet count was 98,000 which is sort of low. My doc said that this is probably due to the mechanical aortic valve that I have. Has anyone heard of this before? He had the lab do another blood test this morning and I am still waiting for the results. I am very healthy and everything else on the blood work looked fine. Any thoughts? Thanks in Advance.
 

netmiff

Well-known member
Joined
Nov 4, 2007
Messages
1,571
Location
the Classic Car Capital of Canada
Apparently the action of the mechanical valve can break certain components of the blood. I think that platelets are one of them. Other, more knowlegeable ones, should be along shortly, but that is a quick answer for you.
 

Nancy

Well-known member
Joined
Jun 10, 2001
Messages
9,896
Location
upstate New York
Yes, my husband had low platelets quite often. He had two mechanicals, one of which was quite an old model. He also had other anemia problems.

He was on prescription strength folic acid, iron pills and ProCrit injections which I gave him 3 times per week.

But sometimes, the low platelets showing up can be a result of letting the vial of blood hang around too long in the lab before testing it, and it can start clumping which throws everything off. So there were times when his doctors ordered another test (STAT) to make sure.

Eventually, he was under the care of a hematologist who had a lab right in his office and the tests were much more reliable, but he still needed lots of help with his blood levels.

You may not be as bad as my husband, and it is possible that with the next test things will have straightened out.

Low platelets caused Joe to develop spontaneous purple spots on his hands, and other bruising.

If it continues and becomes a problem, I think a consult with a hematologist is a good idea.
 
G

Guest

Guest
Hi.
I found out today that my platelet count was 98,000 which is sort of low. My doc said that this is probably due to the mechanical aortic valve that I have. Has anyone heard of this before? He had the lab do another blood test this morning and I am still waiting for the results. I am very healthy and everything else on the blood work looked fine. Any thoughts? Thanks in Advance.
I have low platelets, was evaluated by a hematologist years ago, which included a bone marrow biopsy to make sure it wasn't something else. They do not know why I have this problem, except that my platelets are coated by an anti-body which means my immune system attacks them. When I get sick, my count can drop. I never dipped below 115K. I also take coumadin so prior to my surgery, I saw an excellent hematologist here in Austin, to ensure my stability and discuss coumadin effects with platelets.

When I went for my post op visit with him, my platelets actually rose to 168K with aspirin therapy. We were both pleasantly surprised as my count had not been that high in years! I asked if my defective valve could have been causing my platelet issues. He said it was possible as valves effect red blood cells. Post op it's usually the red blood cells that are destroyed by the mechanical valve. That's why you can develop anemia post op. I have not had a problem with this so far.

Things to keep in mind: Aspirin and all non-steroidal meds effect your platelets. Aspirin puts your platelets to sleep for 10 days. This can also cause more bruising. I have been advised that if my platelets were to drop to 75K, they would have to intervene because I'm on coumadin. All types of medication can effect your platelets, it's important to monitor your platelet count, and make sure nothing more serious is going on.

Illness can lower your platelet count. If you have an infection, that may be the cause.

My husband also has a platelet issue, he is monitored regularly, every 6 months, by a hematologist. They do blood counts first, see the hematologist second, all in one visit. His problem was caused by being exposed to some type of toxin, yet we can't identify what toxin caused this. His count hovers in the 90s. He has not had any serious problems so far.
 

ALCapshaw2

Well-known member
Joined
Mar 20, 2003
Messages
6,910
Location
North Alabama
Hemolysis is a known performance issue with older mechanical valve designs. What kind of valve did you receive?

Here is the first part of what Wikipedia has to say on the subject of Hemolytic Anemia

Hemolytic anemia
From Wikipedia, the free encyclopedia

Hemolytic anemia is anemia due to hemolysis, the abnormal breakdown of red blood cells (RBCs) either in the blood vessels (intravascular hemolysis) or elsewhere in the body (extravascular). It has numerous possible causes, ranging from relatively harmless to life-threatening. The general classification of hemolytic anemia is either acquired or inherited. Treatment depends on the cause and nature of the breakdown.

In a healthy person, a red blood cell survives 90 to 120 days in the circulation, so about 1% of human red blood cells break down each day. The spleen (part of the reticulo-endothelial system) is the main organ which removes old and damaged RBCs from the circulation. In healthy individuals, the breakdown and removal of RBCs from the circulation is matched by the production of new RBCs in the bone marrow.

In conditions where the rate of RBC breakdown is increased, the body initially compensates by producing more RBCs; however, breakdown of RBCs can exceed the rate that the body can make RBCs, and so anemia can develop. Bilirubin, a breakdown product of hemoglobin, can accumulate in the blood causing jaundice, and be excreted in the urine causing the urine to become a dark brown colour.

See Wikipedia for "the rest of the story"
and/or Google "Hemolysis"
 

T-Money

Well-known member
Joined
Apr 2, 2005
Messages
117
Location
Louisiana
Thanks!!!

Thanks!!!

Hi All.
Thanks for the speedy replies. I received my valve in 2005, but it is one of the older St. Jude models (whichever one has been around for 15-20 years and is considered super reliable--Master's Series or Regent I think). I will update everyone tomorrow when my 2nd blood panel comes back. Hopefully it is one of those issues of sitting in the vial too long. Again, thanks everyone!!!!
 

Lynlw

VR.org Supporter
Joined
Jul 15, 2005
Messages
6,541
Location
NJ
Hi All.
Thanks for the speedy replies. I received my valve in 2005, but it is one of the older St. Jude models (whichever one has been around for 15-20 years and is considered super reliable--Master's Series or Regent I think). I will update everyone tomorrow when my 2nd blood panel comes back. Hopefully it is one of those issues of sitting in the vial too long. Again, thanks everyone!!!!
Quite a few things cause low platelets, have you noticed any more bruising than normal ect? I think if it was related to your valve at all, hemolysis, all of your blood counts would be lowered, red, white, ect and not just the platelets.
 

cp172

Well-known member
Joined
Dec 26, 2007
Messages
505
Location
Middle Ga.
Six months after my MV repair I became anemic. After several tests it was decided that something was damaging my red blood cells.The best guess is that the problem was related to my surgery and I was put on a prescription vitamin. Other than coffee colored urine I am fine. I see my hemotologist once a year to double check my blood count.
 

ALCapshaw2

Well-known member
Joined
Mar 20, 2003
Messages
6,910
Location
North Alabama
The St. Jude Master's Series has evolved for over 30 years and has a good record for durability.

The St. Jude Regent came out after the On-X Valves came to market in 1996 and has *some* improvements similar to the On-X but not all.

I recall a post from a member with a Regent Valve stating that her blood was "Blenderized". You can try to find that post by doing a Search for that word and selecting "any date" in the lower left option window of the Extended Search page. EDIT - No Joy - possibly another victim of the (former) Posts being Deleted when members resign policy.

As others have indicated, another "STAT" test would be a good idea to confirm the result. I'm thinking that iron supplements are often prescribed for this condition.

'AL C'
 

Lynlw

VR.org Supporter
Joined
Jul 15, 2005
Messages
6,541
Location
NJ
The St. Jude Master's Series has evolved for over 30 years and has a good record for durability.

The St. Jude Regent came out after the On-X Valves came to market in 1996 and has *some* improvements similar to the On-X but not all.

I recall a post from a member with a Regent Valve stating that her blood was "Blenderized". You can try to find that post by doing a Search for that word and selecting "any date" in the lower left option window of the Extended Search page. EDIT - No Joy - possibly another victim of the (former) Posts being Deleted when members resign policy.

As others have indicated, another "STAT" test would be a good idea to confirm the result. I'm thinking that iron supplements are often prescribed for this condition.

'AL C'
Iron is for Red Blood cells, low hemoglobin. Low platelets are usualy because not enough are being formed, or are being destroyed to quickly, in the spleen ect.
 

T-Money

Well-known member
Joined
Apr 2, 2005
Messages
117
Location
Louisiana
Update-Final Verdict on Low Platelet Count

Update-Final Verdict on Low Platelet Count

Hi All.
First, thanks to everyone that answered the call when I put the original message out. After going to a hematologist, I learned that my low platelet count is being causes by my valve. Originally, I had a low platelet count and a normal red count. After further testing, the doc was able to determine that there is red blood cell destruction going on and my bone marrow is producing red cells at almost twice the normal rate to replace them. This helped to make sense out of the original finding of low platelet with normal red count. My platelet count may not get back into the normal range, but is still high enough not to cause problems. Thus, all is well. Thanks again for all of your quick responses.
T
 

Lynlw

VR.org Supporter
Joined
Jul 15, 2005
Messages
6,541
Location
NJ
Hi All.
First, thanks to everyone that answered the call when I put the original message out. After going to a hematologist, I learned that my low platelet count is being causes by my valve. Originally, I had a low platelet count and a normal red count. After further testing, the doc was able to determine that there is red blood cell destruction going on and my bone marrow is producing red cells at almost twice the normal rate to replace them. This helped to make sense out of the original finding of low platelet with normal red count. My platelet count may not get back into the normal range, but is still high enough not to cause problems. Thus, all is well. Thanks again for all of your quick responses.
T
Thanks for the update, that makes more sense, both the RBCs and platelets being affected. I'm glad to hear it shouldn't cause problems and can be explained.
 

TXGal

Well-known member
Joined
Feb 11, 2009
Messages
197
Location
Texas
I recall hearing this before over the years about our mechanical valves breaking down blood platelets.. glad all is well
 

kbheart

Well-known member
Joined
Mar 30, 2007
Messages
264
Location
Kent, OH
Lovenox & Platelets

Lovenox & Platelets

Sorry to reply so late to this thread but I just found out my platelets are at 98,000, too. I've been on Lovenox for the past 10 days due to some surgeries and it turns out that lovenox can also affect your platelet counts. My platelets fell from 130,000 before starting the Lovenox to 98,000 today. I'm anxious to see if they start going back up since I finally stopped the Lovenox today.
 

Latest posts



Top